All Activity
-
jssailem replied to the thread Pre-launch diesel maintenance questions.OK The manual is always a reasonable place to start to look for answers. 20b two-30b-30c three operators manual 36906 rev 5.pdf The... -
-
Stu Jackson replied to the thread Power station vs AC.Sure, some people think that in an emergency when they need to connect two battery banks it's just as easy to use jumper cables than to... -
SycloneDriver replied to the thread Power station vs AC.Please explain. -
Don, it's brought to you by the same guys who think jumper cables are the answer to paralleling batteries instead of a switch...
-
Stu Jackson replied to the thread Power station vs AC.Don, it's brought to you by the same guys who think jumper cables are the answer to paralleling batteries instead of a switch...
-
SycloneDriver replied to the thread Power station vs AC.The added capability is the benefit. It comes down to comfort mostly. To a lesser degree it's safety, I get overheated easily and now...
-
Stu Jackson replied to the thread Tightening Engine Belt.My contributions to our C34 Forum linked in John's notes today were written in 2008 & 2009. Seems like only yesterday...:clap:
-
Stu Jackson replied to the thread Pre-launch diesel maintenance questions.WAIT!!! That petcock appears to be on the heat exchanger. If so, then you need to leave the petcock alone because all it drains is...
-
quick note: The threads in the nut to be removed are the usual "right handed" threads .. (Unscrew from block in usual direction) But the... -
jssailem reacted to kloudie1's post in the thread Pre-launch diesel maintenance questions with
Helpful.
quick note: The threads in the nut to be removed are the usual "right handed" threads .. (Unscrew from block in usual direction) But the... -
Ddlochner replied to the thread Pre-launch diesel maintenance questions.Once upon a time I had a Volvo MD7A diesel with a similar problem. After dutifully paying an exorbitant amount for an official Volvo...
-
Change it pre haul out or after winter lay up; in either case, run engine for 5 minutes or so to heat the oil. At some point you’re... -
kloudie1 replied to the thread Pre-launch diesel maintenance questions.quick note: The threads in the nut to be removed are the usual "right handed" threads .. (Unscrew from block in usual direction) But the...
-
@JamesG161 beat me to it. I've used Rustoleum with great results.
-
jssailem reacted to Maine Sail's post in the thread Crimp Heat-Shrink Terminals Like a Pro, On a DIY Budget with
Like.
Links can be found here or by clicking "more " in the YouTube video. Crimp Heat-Shrink Terminals - Marine How To
