All Activity
-
CI agree looking at the imprint in the factory non skid the base plate for the mast is at least an inch or two to starboard of where it...
-
CWell, I believe that I see something amiss. Now, it could be just the way you held your camera but when I magnify your picture, it...
-
CUnless the motor mounts are completely destroyed, meaning the rubber is no longer bonded to the metal, I'd leave them alone. The cost...
-
Ccaptcoho replied to the thread engine mount rubber.Be careful not to change the shaft angle
-
CSorry, didn't see the M25 in the OP question. Still though, I don't think it is wise to try and replace just the rubber given that most...
-
CIf you have a Yanmar, I don't think there is a way to just replace the "rubber." The rubber on the Yanmar engine mounts are bonded to...
-
Johann replied to the thread West Marine dropping Blue Seas for Egis.Seems like it with some products at least… others are different. -
Johann reacted to Stu Jackson's post in the thread West Marine dropping Blue Seas for Egis with
Like.
https://www.egismobile.com/ -
This morning West Marine sent out an email announcing they are dropping Blue Seas and will be stocking products from Egis. Has anyone...
-
RussC replied to the thread my DIY spinaker sock.The sail I'll be using has 26'10" luff 24'4" leach and 17'3" foot. -
jaysweet replied to the thread Speedseal It's Back????.When you go to that link, it says "sold out". That's what I was getting at. -
BigEasy replied to the thread (Oceanis 373) Water drainage from starting battery spot to main bilge pump reservoir.Have a similar configuration on my 06 Oceanis 343. Years ago, I had a leaking thru hull fitting for shaft seal cooling water & water... -
BarryL replied to the thread Helping New Boaters.Hello, I don't have any good suggestions for you. I think that TIME is the most precious commodity required for sailing. This is for... -
jssailem replied to the thread Feeling Sluggish?.I added a parameter: Joy = 10cubed Joy = sipping coffee, watching the sunrise over the bay from the back of your sailboat! -
Lots of responses. Thank you! I'll try to offer up some context. First, membership dues are not a barrier for our club. We charge...