All Activity
-
AaronD reacted to Cap'n Deke's post in the thread Anyone know what this is? De-lamination and unusual "red" material (under cabin) inside "bilge" area with
Helpful.
Dave nailed it. The only things I would add are that: You can save yourself some angst if you buy fiberglass tape rather than cut... -
Ddlochner replied to the thread O'Day 19 Centerboard.This won't work because the CB will float and may not be stiff enough. Centerboards are usually either all metal or fiberglass with lead...
-
Use BedIT butyl tape. It's a synthetic blend made specifically for deck hardware. It's also a lot less messy -
jssailem replied to the thread Replacing AC wiring to outlets.Ralph… there is always the possibility that someone used Wire Nuts on the AC cable connections.:biggrin: :yikes::yikes::yikes:
-
I'd be willing to bet the short is inside an electrical box. Stranded marine 3 wire cable is tougher than tough and incredibly...
-
That's assuming it's not solid NMD Cable.:biggrin::(
-
jssailem replied to the thread Whisker pole questions.I have the same pole. It is the original style as you describe. There is a procedure to handle this style of pole. IT will take some...
-
I have a Majestic UFO X antenna about 52' off the water on my mast. It does a good job for stations that are 15-40 miles away. The...
-
jssailem replied to the thread 12 volt electrical system.Welcome to the SBO Forum. I would trace the seatalk cable (identified in yellow) from any of the sensors. I would start with the GPS...
-
Muttondressedaslamb replied to the thread Universal M25 XPB starter burned out..I did, in fact blow the fuses on both D4 batteries. No power was going anywhere to the boat. Replaced the starter anyway as it was... -
fred1diver replied to the thread Whisker pole questions.You could always drill out the rivets and switch them around -
Gene Neill replied to the thread Whisker pole questions.Good question! Twist lock. -
shemandr replied to the thread Whisker pole questions.Does the pole extend via twist lock or by lines? I think you can remove the spike fitting and replace it with a jaw fitting. Usually... -
Lleo310 replied to the thread Replacing AC wiring to outlets.On our 310 we have only 2 GFI that protects the 110 system. 1 for Port other Starboard side.
-
Ddlochner replied to the thread Anyone know what this is? De-lamination and unusual "red" material (under cabin) inside "bilge" area.Yes, you can use an oscillating tool to remove as much of the tabbing as you can. Sanding and/or grinding is still necessary before...
