All Activity
-
JamesG161 reacted to jssailem's post in the thread Invest 98L --> TS Melissa --> Hurricane Melissa with
Like.
Good Monday Morning. Over the weekend Melissa has organized into a dangerous Hurricane. The NHC is forecasting a 4-5 class storm. The... -
Since you need to remove the whole gooseneck fitting anyway you can measure the length accurately when it is disassembled. Or maybe... -
jssailem replied to the thread Invest 98L --> TS Melissa --> Hurricane Melissa.Good Monday Morning. Over the weekend Melissa has organized into a dangerous Hurricane. The NHC is forecasting a 4-5 class storm. The...
-
-
jssailem replied to the thread Spin-Tech Furler.Good idea. I have a feeling the Pacific NW and Canada will soon be sending you some winter weather. Looks like the temps will be in the...
-
-
We wont have until after this week. We are heading to boat to winterize and strip canvas.
-
jssailem replied to the thread Running light corrosion.Yes I agree it is pricey, but it seems to work better than the other products I have used. Better than WD-40. Not sure why. I applied...
-
Ccokomo replied to the thread Spin-Tech Furler.We wont have until after this week. We are heading to boat to winterize and strip canvas.
-
Leeward Rail reacted to sv_regulus's post in the thread Possibly wrong boat, but dreaming. with Like.
Thank you! I'm not sure about the hours on the engine unfortunately, as the previous owner didn't connect the hours meter. Either way... -
FastOlson replied to the thread Rudder packing gland.while the rudder is out try to pump some (way overdue?) grease into that factory 'zerk'. Hope it works, and... then pump in a lot while... -
It looks to be the same type used on the early Hunters. It operates the same way as the cutlass bearing on the prop shaft works, except...
-
Elmers Glue
-
Your engine isn't going to get you to Hawaii - your sails will. That keel bolt definitely needs looking at. The five fundamentals for...
-
Ddlochner replied to the thread Hull preparation.Painting would be the best bet. There is still a lot of gelcoat and pain on the boat. The only place where the gelcoat has been removed...
-
Ddlochner replied to the thread Yanmar 2YM15 anode replacement.Try heat, use a hot air gun and if that fails try an impact driver. It will probably need a ½" driver.
-
Gene Neill replied to the thread Lifeline Stanchion Installation 1987 Catalina 22.A cutoff wheel. Watch out for those wires. ;)
