All Activity
-
kloudie1 replied to the thread Universal M25 XPB starter burned out..Many Kubota dealers know of the agreement between Westerbeke/Universal and the tractor parts places; that agreement forbids the knowing... -
Here are photos of my construction drawings, water lines, buttock lines, and diagonals drawings, wooden half hull model, artist... -
Don S/V ILLusion replied to the thread To drill or not to drill....Good idea! -
kloudie1 replied to the thread Ceramic heater on board?.Same here, on those three cold nights in January down here in Louisiana, I have used a ceramic heater many years. I do not run the water...
-
The solenoid is in the compartment behind the battery switches. Disconnect the negative on all batteries then remove the 4 screws. On my... -
Ouch. It is nice that modern phones have additional lockout features. It also is kind of scary how we reliant we are on them nowadays...
-
Assuming you have a 30A traditional Hubbell style shore power connector, I’d probably be comfortable with the 1500W heater, but I’d...
-
We have used one of those for years, at the dock. Being cautious I always set the heat for about half off the potential output. For...
-
Claude L.-Auger replied to the thread Ceramic heater on board?.I sleep on board frequently until mid-october. When connected to shore power I have an electric heater that has 3 settings: fan, 750... -
Ddlochner replied to the thread To drill or not to drill....Assuming the hole will be drilled through a wood panel, no problem if you seal the sides of the hole with some epoxy. And don't you...
-
Allan12210 replied to the thread Ceramic heater on board?.We used a ceramic heater for a while. It was only warm in the direct area of the airflow. The rest of the boat felt cold. We switched to... -
Davidasailor26 replied to the thread Strategies and techniques for solo heavy weather sailing.In heavier air I run 2 turns on the lazy sheet and 4 on the working sheet. With the 2 turns I’m able to pull the new sheet in quickly... -
Ddlochner replied to the thread Ceramic heater on board?.We have frequently used a ceramic heater on board. As @Davidasailor26 said, keep other electrical loads at a bare minimum while running...
-
eherlihy replied to the thread O’Day 28 gelcoat color.Digging deeper into the issue with the gelcoat that I had; It seems that gelcoat has a shelf life of approximately a year. I know that... -
FastOlson replied to the thread Ceramic heater on board?.We have used one of those for years, at the dock. Being cautious I always set the heat for about half off the potential output. For...
