All Activity
-
kappykaplan replied to the thread Bilge Float Switch.:plus:I've had one for many years and it still works flawlessly. -
jssailem reacted to JamesG161's post in the thread Invest 92L --> TD7 --> TS Gabrielle --> Hurricane Gabrielle with
Like.
A very wide storm! Note the Zone is Wide too! Dammit Jim... -
jssailem reacted to JamesG161's post in the thread Invest 92L --> TD7 --> TS Gabrielle --> Hurricane Gabrielle with Like.
-
jssailem reacted to JamesG161's post in the thread Invest 92L --> TD7 --> TS Gabrielle --> Hurricane Gabrielle with Like.
That storm band = 1000 miles long :facepalm: Dammit Jim...
-
RE: Hunter 49 / Marlow Hunter 50 4jh4 Raw water pump impeller replacement - another strategy As many of you know, access to the raw...
-
jssailem reacted to FastOlson's post in the thread Looking for Boarding Mat Suggestions with
Helpful.
We have an off-n-on membership at Camping World, and every year or three spend some shopping time there. They have all sorts of 'mats'... -
jssailem replied to the thread Main Sheet Block O'day DS 1972.If the boat is 53 years old, the original equipment may only be found in a salvage yard. This company may have similar pieces from...
-
Ddlochner replied to the thread Bilge Float Switch.Float type bilge pump switches are notorious for failing. Replace with an electronic switch or an Ultra Safety Switch.
-
jssailem replied to the thread Painting Boat Bottom.....Copper Free Ablative Paint??.More than enough. My 35ft boat took 2.5 gallons with that coverage.
-
Richard19068 replied to the thread Bilge Float Switch.As Tally Ho suggested, are you sure the bilge is full enough to trigger the switch. Mine takes quite a bit of water to get going but... -
Captain Larry-DH reacted to Leeward Rail's post in the thread vinyl lining separated from the fiberglass hull with Like.
This. That foam prevents just gluing it on again with 3m adhesive. Larry has clearly been there. What a PITA. -
kloudie1 replied to the thread 2QM20 YP-7M gearbox lubrication question.I see what ya mean.. You may be on to the answer with the dust seal observation.. The seals/shields are not very hard to remove.. or new... -
JamesG161 reacted to jssailem's post in the thread Painting Boat Bottom.....Copper Free Ablative Paint?? with Like.
I applied two coats across the hull and a third coat on the leading edges of the Rudder, Bow, Keel, and bottom of the keel. When I... -
JamesG161 reacted to jssailem's post in the thread Painting Boat Bottom.....Copper Free Ablative Paint?? with Like.
Bottom paint performance is associated with the waters you sail and the frequency you sail or clean the bottom. In cold ocean waters...
-
Ccolemj replied to the thread Fridge/Freezer adjustment.You have a separate freezer and fridge, with each containing a holding plate, but both plates are connected to one compressor? Or is...