All Activity
-
If you have access to a sewing machine, make your own. They will be a lot less expensive than commercially produced curtains... -
AArt12050 replied to the thread Why hasn't anyone made a robot to clean our boat bottoms?.Agree with ShawnL, our season here in the Northeast is equally as short. We usually haul in late September. As mentioned, when boats are...
-
Don S/V ILLusion replied to the thread Keel/Hull Crack on Splash.The bottom of the keel looks fine which obviates the dropped explanation. I doubt the worst possible position of a sling could do that... -
AArt12050 reacted to ShawnL's post in the thread Why hasn't anyone made a robot to clean our boat bottoms? with
Like.
Our seasons are very short in the far northern midwest, so it wouldn't pay for us. I did see an episode of Sam Holmes Sailing on... -
kloudie1 replied to the thread Yanmar 3GM30F: Wiring Harness & Aftermarket Panel.No comment on the alternator field and regulator.... just reference, this is a picture of the OEM solenoid just below the air filter... -
-
Joe replied to the thread Assymetric for a 27.3.The spinnaker halyard will always need to be ahead and above the jib halyards. No matter the boat. Because the sail rides ahead and... -
Mine is the same size for the waste tank. Not at the boat now, Hope this helps. Cheers -
Joe replied to the thread In search of a rudder transom mount for a Point Jude 16.Aha! That's all we need. The line simply locks the rudder down using the cord and a clamceat. As far as I can determine there're no...
-
shemandr replied to the thread Hunter 40-1 Refit - Will the Engine Start?.That's a great write up. I think just about all inboard engine boater's have those same thoughts when starting an engine after layup. -
DaveJ replied to the thread Help with Diesel Tank Cap dimension.Mine is the same size for the waste tank. Not at the boat now, Hope this helps. Cheers -
shemandr replied to the thread Short but sweet...I've come off fast boats with my back compressed. Not fun! 15 knots is about as fast as I care to go.
-
shemandr replied to the thread Why hasn't anyone made a robot to clean our boat bottoms?.Anyone who has cleaned a bottom in the water learns pretty fast that they need to use suction cups to keep brush strokes from pushing...
-
Hello Below reacted to Michael Davis's post in the thread Circumnavigating Vancouver Island with Like.
Rounding Race Rock. Back in the Salish Sea. So close to home I can taste it. Brown Ridge on Saturna. Tonight we are in Port Sidney... -
Nice finds! Tks for sharing. :beer: -
FastOlson replied to the thread Why hasn't anyone made a robot to clean our boat bottoms?.There may be other reasons why this service/device has not happened. About 20 years ago we had a hull scrubbing machine appear at a...
