All Activity
-
jssailem replied to the thread Galley table.There are no short cuts to what they did. There are alternatives which will provide results but may not be the same. The question is... -
If it is laminate, replacement is the standard way. You can use a heat gun and acetone to peel up the old laminate. Use a putty knife...
-
Mike Thomas with this forum store should know as he was an hunter employee
-
fred1diver replied to the thread Sail Slides.We want pics -
Terry Cox replied to the thread Preventing a hood furler housing from rotating.What secures the lower housing from rotating now, the stem chain plate? A picture would help. -
shemandr replied to the thread Keel joint work.I really hate to tell a guy, who's just getting back into sailing, to do more work first. But I think the whole keel needs to be taken... -
jssailem reacted to Stu Jackson's post in the thread Dock power and interior lights- questions. with
Like.
They built over 6,000 Catalina 30s. The manuals ARE out there. Catalina 30 Groups Links Subscribe at the web forum: Catalina30... -
jssailem replied to the thread Air in fuel feed.Pictures are a big help. Air will find a way into your lines on the vacuum side of the lines. If you see bubbles then you have a leak as...
-
Yes I have heard of a pin hole on the pickup tube above the fuel level.
-
Ddlochner replied to the thread Keel joint work.To treat the keel it needs to be brought to bright metal and coated with Ospho or similar rust treatment. TotalBoat sells a product that...
-
buddy0 posted the thread Access under cabinet/desk in vberth on Beneteau 40 in Ask A Beneteau Owner.Any ideas on how to get under the cabinet/desk on the starboard side in the vberth on a 2008 Beneteau 40? It appears to be installed as... -
-
jssailem reacted to Project_Mayhem's post in the thread 0.04 or 0.06" seizing wire for turnbuckles? with Like.
Ive done this with non-mission critical turnbuckles. In some cases a single zip tie per turnbuckle was enough
-
jssailem replied to the thread repowering the engine.Could have been plumbing fittings.
-
jssailem replied to the thread repowering the engine.I used Stainless pipe fabrication done locally. Pipe threaded to exhaust manifold.
-
Don S/V ILLusion replied to the thread repowering the engine.That’s what the elbow is -plumbing parts!
