All Activity

  • B
    I need a oil filter for my Yanmar 3QM30 cutter.
  • kloudie1
    On my boom, The reefing lines go from the cabin roof cleat through the "tunnel" to the deck organizer. From there, to the small blocks...
    • P1000700.JPG
  • jssailem
    Timely. I have split pins securing the turnbuckles. They were /are wrapped with nice white electrical tape. I read on the almighty...
  • jssailem
    jssailem reacted to Project_Mayhem's post in the thread Keel joint work with Helpful Helpful.
    A few people have stated that the key to keeping rust away is to seal it as soon as you remove it. As in minutes, not days. Those people...
  • shemandr
    shemandr replied to the thread Sail Slides.
    Looking at the Bainbridge section of the US Fisheries website I note many varieties of slide style based largely on the track style you...
  • jssailem
    jssailem reacted to Indysailor's post in the thread Keel joint work with Like Like.
    I can't offer more than what others will contribute, except to say that the story of someone getting through life, work and health...
  • LakeOntario270
    LakeOntario270 reacted to Project_Mayhem's post in the thread Keel joint work with Like Like.
    A few people have stated that the key to keeping rust away is to seal it as soon as you remove it. As in minutes, not days. Those people...
  • Joe
    Are you also missing the upper wooden part of the rudder that attaches it to the boat? How about the hinge bracket for the tiller? If...
  • jssailem
    jssailem reacted to colemj's post in the thread ELCI breakers ?? with Like Like.
    ELCI are not surge protectors. While it is possible the strike may have created a current imbalance on the L and N lines which caused...
  • C
    colemj replied to the thread ELCI breakers ??.
    ELCI are not surge protectors. While it is possible the strike may have created a current imbalance on the L and N lines which caused...
  • jssailem
    jssailem replied to the thread ELCI breakers ??.
    Bluesea has a good article about this subject...
  • I
    ice breaker reacted to bhr10950's post in the thread Galley table with Like Like.
    I got a reply from Mike Thomas at Hunter Parts, and he gave me the procedure to refinish the top. It is wood veneer so it can be...
  • C
    CYQK replied to the thread ELCI breakers ??.
    Well...... I installed ELCI breakers on my boat Yesterday there was a huge lightning strike to a boat a couple slips over Breakers...
  • jssailem
    jssailem reacted to colemj's post in the thread What to do with Old Norseman Fittings with Like Like.
    We have Norseman, but recently replaced the forestay turnbuckle with a StaLock. There isn't any difference in using either, with the...
  • jssailem
    jssailem replied to the thread ELCI breakers ??.
    I upgraded to a new ELCI AC breaker panel and installed a galvanic isolator. No more problems...