All Activity
-
DaveJ replied to the thread Picking up a mooring ball..Yes! I knew about it but didn’t know the name. I think Santa will bring me one this year. cheers -
Stu Jackson replied to the thread Recommissioning head and holding tank.Many of us have used the head sink drain tapped into the head input so as to use fresh water for the LAST flush before leaving the boat... -
Ralph Johnstone replied to the thread Recommissioning head and holding tank.No relationship at all. The holding tank is (should be) completely sealed. The contents, no matter how foul, are not causing the... -
Iice breaker replied to the thread Boom Vang.I am not sure what boat you have, but on our 41AC, the rod kicker is primarily used to hold up the boom when the sail is not deployed...
-
Davidasailor26 reacted to American_Mainsail's post in the thread Hunter 42 Passage Grounding wires in center bilge. with
Like.
Nowhere - a quick check you can do is to turn off all of your DC switches, disconnect your battery +, and put an ammeter (multimeter in... -
kappykaplan replied to the thread Outboard setup on Pearson 30.The problem with this is that the rudder is in front of the motor, so you'll not have any real steerage until the boat is moving (just... -
JoeWhite replied to the thread Air in fuel feed.I am not sure how the fixture is assembled on my fuel tank. If you are concerned that the tube may fall down into the tank, can you... -
dehler25 replied to the thread Air in fuel feed.Took a while to get back, thanks for the response. I pulled the insert adapter that threads into the large nut on the tank, it has a... -
RussC replied to the thread Merit 22 owners.latest addition finished up yesterday. I'll never forget to bring the ladder again :). -
-
dehler25 replied to the thread Air in fuel feed.It is air coming up the feed from the tank
-
Pimps need to be paid. Bad things happen when you dont pay your pimps Do these share a common breaker, bus bar, ground, etc? -
FastOlson reacted to testingthewaters91's post in the thread Seacock Quality... Replace?—Currently on the hard. with Like.
Spent today grinding and glassing up a couple of old through-hulls. The hull’s about 1/2" thick fiberglass, so I made a 7-inch...
-
FastOlson replied to the thread RIP my Canadian friend (almost)…saved by a MOB move!.My first Tilly hat was indeed replaced by the factory when it started coming apart. The new hat arrived with a warning to launder it...
-
Davidasailor26 replied to the thread Hunter 42 Passage Grounding wires in center bilge..What do you mean by voltage differential? Along which wire are you reading a differential, if these are disconnected completely? If...
-
jssailem reacted to testingthewaters91's post in the thread Seacock Quality... Replace?—Currently on the hard. with Like.
Thank you! I'm glad to hear it. Will sand it and fair it today.
