All Activity
-
jssailem reacted to Alan Gomes's post in the thread DockEdge Visa or Thetford 550 MSD Porta Potties on 26' Live Aboard? with
Helpful.
Yeah, completely different pump. It does have "bracket issues." I've reported them; maybe you read that. Perhaps others have as well... -
Poor workmanship. I've found sawdust and a few pieces of construction debris in several hard-to-access spaces in the boat.
-
In the forward cabin, I removed the aft drawer under the bunk. I was surprised to find a relatively large empty space below the level of...
-
jssailem reacted to Tally Ho's post in the thread RIP my Canadian friend (almost)…saved by a MOB move! with
Like.
I was sailing by myself, wasn’t really ready to go in, and decided the MOB drill would be fun :huh: Greg -
jssailem reacted to Tally Ho's post in the thread RIP my Canadian friend (almost)…saved by a MOB move! with Helpful.
It was a sporty sail for sure, and the waves made the recovery much more difficult! A big one hit Tally Ho broadside about the time I...
-
jssailem replied to the thread Removal of Yanmar 4jh3e from Hunter 420 Passage.Engine’s can be removed and replaced. I did it on my Cal 35 Cruiser. I think it migh be easier on your 420 Passage. Before you start...
-
jssailem replied to the thread Do i feel ssttuuiippiidd!.Captain George Vancouver named the water Puget’s Sound to honor British Naval Officer Lieutenant Peter Puget, who surveyed most of the...
-
I don't think the core would need to be HDPE, just some reasonably slippery plastic. Nylon would be very good, but also problematic to... -
Ralph Johnstone reacted to Stu Jackson's post in the thread Removal of Yanmar 4jh3e from Hunter 420 Passage with Ha.
If the engine is still in your boat, then probably not. :cool: Have you looked? -
Richard19068 replied to the thread Do i feel ssttuuiippiidd!.Not a change. Puget sound is a (small) part of the Salish sea. "The USGS defines Puget Sound as all the waters south of three... -
thinwater replied to the thread 3d printing for boats..I don't think the core would need to be HDPE, just some reasonably slippery plastic. Nylon would be very good, but also problematic to... -
Richard19068 reacted to Stu Jackson's post in the thread Removal of Yanmar 4jh3e from Hunter 420 Passage with Ha.
If the engine is still in your boat, then probably not. :cool: Have you looked?
-
Stu Jackson replied to the thread Removal of Yanmar 4jh3e from Hunter 420 Passage.If the engine is still in your boat, then probably not. :cool: Have you looked? -
Tally Ho replied to the thread 41AC - Found a Large Empty Space.Did you run the wires in there? Or were they installed by Hunter to run some option your boat doesn’t have? And where did the sawdust...