All Activity
-
jssailem replied to the thread AI and sailing decision making..“We’ve only just begun”. At least that is the way the song goes. -
I am so done with AI!
-
jssailem replied to the thread Need Help: Prop Shaft Jam Nut Won’t Budge.This is sensible. Cutting the nuts off (that just has a bad sound to the words. Sounds personal) is not always a cure. It is possible to...
-
jssailem replied to the thread Need Help: Prop Shaft Jam Nut Won’t Budge.SO TRUE. It feels like magic.
-
I just looked at that link. While it does give the basics about watermakers, the list of the 5 best ones is horrible. The two most... -
I can't speak to whether a watermaker makes sense on your boat, your cruising areas, or they type of cruising you do, but there really...
-
jssailem replied to the thread Removing Raymarine ST4000+ from Edson Destroyer Wheel — Need Guidance.My thoughts is that would be a weak design for a sailboat steering. That said Edson has a lot of knowledge and they have experimented...
-
jssailem reacted to Tally Ho's post in the thread Removing Raymarine ST4000+ from Edson Destroyer Wheel — Need Guidance with
Like.
I think this is the end of the shaft….and I don’t see any sort of nut on it…. It should pull off. -
jssailem replied to the thread Removing Raymarine ST4000+ from Edson Destroyer Wheel — Need Guidance.Yours maybe a friction fit. Perhaps with set screws holding it in place. I have not seen one of them.
-
Allan12210 replied to the thread Unexplained situation last night.Happened all the time at China Beach State Park in San Francisco Bay. The hydrodynamic lift from the keel was larger than the wind... -
Tally Ho replied to the thread Removing Raymarine ST4000+ from Edson Destroyer Wheel — Need Guidance.I think this is the end of the shaft….and I don’t see any sort of nut on it…. It should pull off. -
-
Ddlochner replied to the thread Removing Raymarine ST4000+ from Edson Destroyer Wheel — Need Guidance.Given the age of the boat and the quirks in how it is put together, now might be good time to service the steering system, check the...
-
Tally Ho replied to the thread Water Tank.We must be missing something…. How many tanks do you have? How are they connected? Do you fill the tank with a hose in an open deck...
-
jssailem replied to the thread Removing Raymarine ST4000+ from Edson Destroyer Wheel — Need Guidance.You can’t do anything with the AP Wheel pilot until you get the Edson wheel off. Let’s focus there. Edson used a tapered and a straight...
-
-
jtm replied to the thread Black smoke on start of my Hunter 28 (2GM20G Yanmar engine).you mentioned you were doing like 1500 rpm. Kinda slow. 2350 to 2800 (wave/wind conditions permitting) is more cruising normal...
