yanmar mounts

[ken matejka]

Does anyone know where I can buy new yanmar motor mounts for a 2GM20F for a good price? I think 90-100 bucks is a little on the high side. Also, my starboard mounts are about 1 cm lower(more worn) than the port mounts. Is this normal? Can I replace the starboard mounts only or is it advisable to replace all four?

 

[John Dodge]

I am New to boat ownership but I was directed to www.torresen.com and found them to have great prices the best out of three that i checked

 

[Kevin]

I would change all.

Dear Ken,Thanks for the note. If you change out the mounts I would change out all. If not you may create greater loads on the two new mounts causing a faster failure rate then normal. Often mount failures are due to the rubber taking a set. The two worn mounts may have greater loads placed upon them but part of the mounts failure is due to the time frame the rubber has been exposed to… same time frame the Ok mounts have suffered. Hope this helps. Kevin