I will be pulling this trim off and reinstalling. It was the source of at least one leak, in the past, and I do not have confidence it was ever properly rebedded. And, it is to the point where the grain is so deep that it is hard to clean well.
So, I will remove and sand to see if I can restore it. But, if not, I will just replace.
I am leaning toward replacement because some of the joints, I think, will never really mate up well again, at this point.
Anyone know of a source for half-round like this? Or, am I going to have to mill my own?
So, I will remove and sand to see if I can restore it. But, if not, I will just replace.
I am leaning toward replacement because some of the joints, I think, will never really mate up well again, at this point.
Anyone know of a source for half-round like this? Or, am I going to have to mill my own?
