I hate the cavernous hole under the sink and stove. The floor is not flat and has only the two small shelves for storing things. Too much wasted space. I am thing of putting a plywood floor in the bottom of the cabinets and using dishwasher buckets to fit the space to organize everything stored under there. Any ideas or working system out there. Many thinks Dale
Storage under sink in galley
- Thread starter quickdraw66
- Start date
- Status
Storage Space
Dale, Great idea! I'm doing some big mods now and that will be a good one. Seems like some 3/8" plywood coated with West System epoxy would do nicely as a floor. It could be secured with adhesive or not, depending upon the need to remove them for cleaning or inspection.
Dale, Great idea! I'm doing some big mods now and that will be a good one. Seems like some 3/8" plywood coated with West System epoxy would do nicely as a floor. It could be secured with adhesive or not, depending upon the need to remove them for cleaning or inspection.
heres an idea
I put these shelves in under the sink, outboard I just used 3M5200 and on the sink side I used small 1/4 by 1/4 inch wood screwed thru the fiberglass and used the 3 M 5200 worked ok, the hardest pard was getting the measurements for the cutout of the shelves themselves, used cardboard and a lot of time getting it right. John
I put these shelves in under the sink, outboard I just used 3M5200 and on the sink side I used small 1/4 by 1/4 inch wood screwed thru the fiberglass and used the 3 M 5200 worked ok, the hardest pard was getting the measurements for the cutout of the shelves themselves, used cardboard and a lot of time getting it right. John
good idea
I did use cardboard last night for a patter to cut the plywood. Well had some 1/4 hard boards laying around, ill make the floor out that. And if it works I will recut with 3/8 plywood and seal with epoxy. Have some pic of the first working pattern, Ill post it later today. Thanks Dale
I did use cardboard last night for a patter to cut the plywood. Well had some 1/4 hard boards laying around, ill make the floor out that. And if it works I will recut with 3/8 plywood and seal with epoxy. Have some pic of the first working pattern, Ill post it later today. Thanks Dale
- Status