Prop Shaft, Combi Drive Lever

[olderthanus <gebaker@10n9th.com>]

Looking to buy a complete (the last two I have bought have been sawed
off at the stern bearing) propshaft (inner and outer) for the Albin
021. Also the 5" engagement lever on the "transmission".

Engine has a home in a displacement launch, not a Vega.

Thanks in advance.

Gary Baker

 

[stevebirch2002]

Hi Gary

I make the outer control tube and have them in stock. They can be cut from one
metre down to waht you want. The inner shaft is 20mm with a single taper and
can be procurred locally from any shaft maker. The outer conrtrol tube is teh
hard bit. It must be exactly 25mm OD with an ID of 21mm. There is a lot of
machining that goes into the manufacture of these, hence the cost of £95

Kind Regards

Steve Birch
At 15:00 21/01/03 +0000, you wrote:

 

[wxt8981]

I have a complete assembly, consisting of prop, shaft and outer
shaft.(from my old 0-21)
and I also have an extra outer shaft.
You can have it free, all you pay is the freight. (I'm in Florida, USA)
Wilhelm V-257olderthanus wrote: