Prop alignment

[paddyb_uk2001]

I've just renewed the combi bearings & seals (thsnks for the kit &
advice, Steve). Everything seems fine but when if I set the
controller to the forward the poropeller blades just don't seem to
have much forward pitch to them. Didn't take a photo at the weekend
when I did it but from memory they go about 20 degrees maybe from
flat (neutral). After putting it together I think it could be only
right or wrong, the control tube seems to have full travel so
hopefully I'm just being a bit panicy but does anyone have a photo
of a prop that i could check with, or some other way of putting my
mind at rest.

Thanks

Paddy Fleur 11 (V3040)

 

[chris20636]

Paddy,

I'll be using the kit to do my combi this spring. Any advice or lessons learned you can pass on would be appreciated. How long did it take? Just one weekend?

All,
During the recondition, what is the best time to check engine alignment and make adjustments. Recommended procedure?

Thanks
Chris
V2933 Renee