Outhaul Sheave for H31

[bobmorning]

Does anyone know the dimensions of a suitable replacement for the outhaul sheave on a Kenyon boom for a 1984 H31?

I have removed the old one but it has disintegrated to the point that there is not enough of it left to get an outside dimension. The width is .400" (3/8 roughly) and the internal dimension is unknown as the hole is warped and a reliable sizing cannot be made.

I've been to the rigrite.com site but without suitable dimensions, I'm in the dark on what to order. The sheave is used with a 3/8" wire rope that runs internal to the boom to the gooseneck at the mast.

If anyone has replaced with an off the shelf sheave, please let me know.

Any info much appreciated!

Bob

 

[Steve Dion]

Why don't you contact Rig Rite. They probably have the exact one in stock. No guessing that way.


http://www.rigrite.com/

 

[Allan12210]

The hole size is the same, plus a few thousandths as the pin that ran through it. Should be able to match to a wire halyard sheave from Rig Rite.