I am attempting to pull a good transmission, (reversing gear) from a trashed YSB-12 Yanmar
I am stuck after removing all bolts securing transmission to bell housing. There is a three inch gap all around between tranny & bell housing.
I cannot get any further. Like there is a step I missed. The tranny moves away from bell housing easily and freely then goes no further.
Any hot tips, ideas. actual knowledge from experience. well wishers?
Thank you very much for any assistance that may be forthcoming.
All the best,
Cap'n Out-of-Action, at the moment.
I am stuck after removing all bolts securing transmission to bell housing. There is a three inch gap all around between tranny & bell housing.
I cannot get any further. Like there is a step I missed. The tranny moves away from bell housing easily and freely then goes no further.
Any hot tips, ideas. actual knowledge from experience. well wishers?
Thank you very much for any assistance that may be forthcoming.
All the best,
Cap'n Out-of-Action, at the moment.