Need bar that slides over to secure anchor locker

[Brian]

I need to locate that twisty little bar that you slide over to lock the anchor locker hatch shut for an 81 Hunter 30. Does anyone have any suggestions?

 

[Jeff Dunham]

If you find one...

Brian,If you find one or the measurements on how to make one, I'm interested!Jeff

 

[JB]

Bicycle cable???

Would a cable and lock do it???

 

[Steve Dion]

Does it look anything like this?

Brian:Does it look anything like this? http://www.sailboatowners.com/upload/display.tpl?folder=Dion73116575969&fno=17I took these measurements and photos for a H'31 owner. He had the part made at TIQ for about $10. You can contact TIQ at www.topsinquality.com

 

[Brian]

For Steve Dion

Thanks for your response about the hatch bar, but when I went to the address you listed the page was blank. Usually when stuff like this happens it is a problem on my end, are there any other links to that address that I can use to get there? Thanks again for your time.

 

[Steve Dion]

Try the related link at the bottom of my post

nm

 

[Jeff Dunham]

Pic of Pin

Steve,If Brian's 1981 Hunter 30 has the same hatch configuration, this pin would not work. The hatch on my '81 H30 was a single piece of aluminum rod stock, about the same diameter, but with two bends. The bends form a handle in the center of the stock. Perhaps your POC could fabricate a handle with deminsions provided. It is worth a try. Brian good luck!Jeff