Mast wiring deck pass thru!

[ttac]

Hello all!
I am looking for the box that I see on the 1990, 91, ... Larger Hunters. It is the mast wire pass thru unit on the deck. I want to find some one that sells them. Our 42 Passage has the wires run down the inside of the mast then thru small pipes to the inside.
I want to change this so the mast can be removed easyer and not have the ends cut off each time.
I found one in Europe that I will show in the photo. But I would like to find one here in the states if possible!
Thank you in advance for your help!
Dean

 

[seadaddler]

Try asking the store here and give them a call

 

[BrianH]

I did the exact same thing to my Hunter 336 about 10 years ago. It solved the issue that I was having with water leaking through the wire access on the top of the compression post.

I got the part from Hunter at the time, though I understand you can get it through this forum now.

 

[Dave Groshong]

We have them here:

http://shop.hunterowners.com/hp/part.php?m=420&c=6&p=52348

 

[Bill Roosa]

OR you could just make longer ends on the mast portion of the wires, connect them to a junction strip so you can just unscrew them when pulling the mast. Also if you look at the mast tabernackle you will find a small square hole on each side. The hole is three sided with the deck forming the forth side. These "lumber holes" drain the bottom of the mast and you have to clean them out occasionally.
Drilling hole in the deck is asking for leaks IMHO.