I have just purchased a new Kabota engine to replace the original engine in my C30 and I am looking for a replacement for the bracket that holds the alternator onto the engine. This bracket connect to the cylinder head allowing the cooling water to flow through the bracket onto the thermostat and recycle process. If there is anybody that can help I would be grateful.
- Status
Interested in Sharing Wisdom?
I can't help you with your parts because I'm a couple of steps behind you. I was hoping to replace my completely seised Universal M5411 with the same thing, but have not had any luck finding one. What Kubota did you end up going with and why? what were the tradeoffs, if any for trying to fit a freshwater cooled (I'm assuming) into that tiny space? What didn't you expect, etc. My I'm full of questions! One last thing - I'm also assuming you are from Brisbane, Australia? i lived there for a year back in 95 on exchange at UQ! Small world!
My personal email is: skeezydoodle@hotmail.com Any advice and insight you could provide would be GREAT!! Thanks, Alison
I can't help you with your parts because I'm a couple of steps behind you. I was hoping to replace my completely seised Universal M5411 with the same thing, but have not had any luck finding one. What Kubota did you end up going with and why? what were the tradeoffs, if any for trying to fit a freshwater cooled (I'm assuming) into that tiny space? What didn't you expect, etc. My I'm full of questions! One last thing - I'm also assuming you are from Brisbane, Australia? i lived there for a year back in 95 on exchange at UQ! Small world!
My personal email is: skeezydoodle@hotmail.com Any advice and insight you could provide would be GREAT!! Thanks, Alison- Status