Installing new tank monitor

S

scottdube

.
Aug 17, 2010
208
Hunter 410 Dover NH
I am in the process of installing the profile 8 tank monitor from Ferriello Sales. I have the water and fuel all set and I am adding his foil senders to the outside of the tank for the waste tanks. Has anyone seen where these wires ( tank sender to gauge) route? I only see one wire at the gauge, the other has to ground somewhere. I'm hoping to reuse it so I need to find it and hope hunter didn't just run it to ground somewhere else.

I highly recommend this gauge it is so nice especially compared to the Wema stuff that was in there.
 
S

scottdube

.
Aug 17, 2010
208
Hunter 410 Dover NH
Peggy he's not up on the model boat I have though I will vouch for his being EXTREMELY responsive no matter what day it is...

I did find the ground though... Anyone with a 1998 410 might find the tank gauges and a couple of other grounds on a buss bar at the back of the start battery compartment. I had to remove the battery and loosen up the floor board for the compartment to ID the wires. But I found it and have the front waste tank working. ID's the rear and have to finish wiring that one up!
 
Peggie Hall HeadMistress

Peggie Hall HeadMistress

.
Dec 2, 1997
8,967
- - LIttle Rock
scottdube said:
I had to remove the battery and loosen up the floor board for the compartment to ID the wires. But I found it and have the front waste tank working.
Click to expand
Not quite yet...you still have to calibrate all the senders. They can't give you accurate readings if they don't know the depth of each tank.
 
Peggie Hall HeadMistress

Peggie Hall HeadMistress

.
Dec 2, 1997
8,967
- - LIttle Rock
They say the marine version is "stronger," but I've found that the household version seems to works just as well in every application I've tried it.
Hope you find the new book useful! I'm always glad to answer any questions it doesn't.
 
You must log in or register to reply here.
Top Bottom