Please advise on the injector parts installation for a Yanmar 3HM35F. I ordered an O-ring, cover and insulator after checking my injectors (initial removal did not have O-rings). Upon reinstallation, do the O-rings go on before the cover (large copper washer) or after which would be against the injector? Thanks
Injector Parts Installation
- Thread starter hkstone
- Start date
- Status
Please contact me via Owner Directory
HKStone, please contact me through the Owner Directory. I have the manual and can send you copies of the pages via email. I'd put them up on the Photo Forum, but when I did, they were just a bit too small to read. Anybody, is there a way to zoom in/out in the Photo Forum?
HKStone, please contact me through the Owner Directory. I have the manual and can send you copies of the pages via email. I'd put them up on the Photo Forum, but when I did, they were just a bit too small to read. Anybody, is there a way to zoom in/out in the Photo Forum?
The o ring goes
aroung the top of the injecter you will see a groove for it, its to keep water out. The copper goes in the injecter hole first then you should have a heat washer that goes next. Hope this helps
aroung the top of the injecter you will see a groove for it, its to keep water out. The copper goes in the injecter hole first then you should have a heat washer that goes next. Hope this helps
- Status