Hello all, I have an Edson Marine Radial Drive, 800-8. The rudder stop was mounted under the drive, opposite what is shown here: Radial Drive Wheel
Last season, my rudder stop broke off and I'm replacing it now before the season starts. I only saw one option on the Edison site for a stop, it's this one: 2" Vertical Rudder Stop (862-2)
I purchased it and I'm starting to take the old one off that's mounted underneath. I'm noticing I only have 1" 1/2 inches of clearance below the radial drive to mount the new 2" 3/8 inch stop, obviously not going to work. What has everyone else done in this situation?
Last season, my rudder stop broke off and I'm replacing it now before the season starts. I only saw one option on the Edison site for a stop, it's this one: 2" Vertical Rudder Stop (862-2)
I purchased it and I'm starting to take the old one off that's mounted underneath. I'm noticing I only have 1" 1/2 inches of clearance below the radial drive to mount the new 2" 3/8 inch stop, obviously not going to work. What has everyone else done in this situation?
