On the Hunter 235 ther is a square hole inthe cockpit deck to mount the table. Is there a cap for the hole. Mine is always full of water from rain, etc. Any suggestion for covering it? Cheap and easy are my middel names. Thansk Hayden
I had the same problem. I crafted one out of woood and put a cedar cap on it then paint the thing bright white. Sits tight in the whole and looks pretty good.
Hayden, We have a similar set up on our H23. We use a round Rubbermaid drain cover approx 5" in diameter (our hole is round). A piece of wood shaped like a hockey puck attached to the underside will keep it from sliding around on your cockpit floor. We used a small wood screw with a washer to attach the drain cover to the wooden hockey puck. Hope this helps. Fair winds and calm seas, Chip Langan SV Nautical Rose H23
We have a 97H26, same size hole, I use a rubber trailer hitch cap, fits tight, looks good, and easy to replace. hope this helps. ps I heard a story about water getting in there and freezing, so probably a good idea to cover it.
The table mounting hole is the same size as most trailer hitch receivers so you can use a receiver cover. They come in all sorts of cool designs, major universities, NFL, Chevy, Dodge, Ford, ---- but not Hunter. Ken S/V WouffHong
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
