Hotknife....

Bob 04 H260 · Jun 24, 2013

Sum, I'm surprised you did not fab one up !

It is a good buy and I am tempted but so far have been happy with a soldering gun I've recycled for this purpose.
Hope you and Ruth are doing well, Bob

tkanzler · Jun 24, 2013

I just use my old Weller or R/S soldering gun, with the original soldering tip, especially since it's too powerful and clumsy for electronics work. The two 'legs' seem to work just fine, though they do have to cut through more than if it was a skinny blade. I suppose I could buy a hot knife tip to replace the soldering tip, but I haven't felt the need yet.

Of course, it's only good for line cutting, not for canvas work, but since I don't do canvas work . . .

Tim R. · Jun 24, 2013

I opted for the budget priced and smaller Weller iron with cutting tip. It does take longer to cut fabric but who's in a rush.

Hotknife....

Sumner

.

Bob 04 H260

.

tkanzler

.

Tim R.

.

Sumner

.