Hood roller furler

[JHS]

Hood roller furler on Hunter 29.5 no longer winds on the drum from top to bottom, etc. ,so I'm getting lots of overrides What part do I need to replace to correct this problem or is there another solution to try.

 

[Justin_NSA]

Make sure the exposed halyard is minimal. You may have to lengthen the lead at the drum.

 

[dlochner]

Check the angle of the furling line. It should be at 90° to the drum. Sometimes the last block shifts a little and it no longer aligns correctly.

 

[Tally Ho]

Sounds like an alignment problem as @dlochner said. Did something change in the geometry?

Would a tired and stiff furling line cause something like this?

Greg