I was hoping someone might know the diameter and length for the fuel fill and vent hoses. If you also know the same information for the exhaust hose from the muffler to the through hull that would be great. I need to change them before spring launch. Thanks in advance!!
H34 fuell fill and vent hose sizes
- Thread starter a65sailor
- Start date
a65...
The fill should be 1 1/2 inch I.D. and the vent should be 3/8 inch I.D. Check the marking as Steve suggested.
The fill should be 1 1/2 inch I.D. and the vent should be 3/8 inch I.D. Check the marking as Steve suggested.
I finally got the hoses sized and purchased. Here is what I found to be the sizes. I ordered a little long since I'm not replacing them till spring and didn't want to remove them to measure.
Wet exhaust hose is 2 inch Shieldflex 2 part number 116-250-200. I ordered 15 feet to replace the entire hose before and after the muffler.
Fresh water intake hose is 3/4 by 6 feet. Shieldflex 2 part number 116-250-034.
Fuel fill hose is 1 1/2 I bought a 10 foot piece because I found it cheaper that way probably only need 6 feet. Part number Shields 116-355-1123.
Fuel tank vent hose is 5/8. I also bought that in a 10 foot piece. Part number Shields 116-369-0583.
Fuel hose to the engine is 5/16. I bought 20 feet to replace both the in feed and the return line. Trident part number 365-0566.
I hope this will help someone at some point.
Wet exhaust hose is 2 inch Shieldflex 2 part number 116-250-200. I ordered 15 feet to replace the entire hose before and after the muffler.
Fresh water intake hose is 3/4 by 6 feet. Shieldflex 2 part number 116-250-034.
Fuel fill hose is 1 1/2 I bought a 10 foot piece because I found it cheaper that way probably only need 6 feet. Part number Shields 116-355-1123.
Fuel tank vent hose is 5/8. I also bought that in a 10 foot piece. Part number Shields 116-369-0583.
Fuel hose to the engine is 5/16. I bought 20 feet to replace both the in feed and the return line. Trident part number 365-0566.
I hope this will help someone at some point.
That is the water in take for engine cooling. Not for freshwater tank filling. I should have been more clear.
Thanks for the clarification. That is generally referred to as the Engine Raw Water Intake
If you plan to replace your exhaust hose, you might just think about how long it has been since you replaced the elbow.
fill hose measurement and replacement
Well, I just went to the Hunter Owners store and got 5' of the 1 1/2" fuel fill hose. I disconnected the hose at the fill cap and pulled it taught from the cockpit to get a measurement. It was 4'3", and I will see what final length works for me on install.