i removed my 2 blade maxprop to change my cutlass bearing, i knew that i wanted to save the settings but was unable to because who ever install it had one blade on upside down! on the attached site it gives the settings to install the prop. my question is; what was the original prop? there is much talk about how hunter changed engines and such. my engine it the yanmar 3 cylinder, 20 horse. i beleive the prop should be the 15 degree. but i should ask the experts. what do you think cheers, mike
fred and others, hunter 34
- Thread starter duality
- Start date
- Status
Mike, The original prop has nothing to do with
your Maxprop. Call PYI tomorrow for your settings. You'll need to provide your engines HP and/@ RPM plus the transmission reduction ratio and your Maxprop diameter. The setting charts are probably online. They'll fix you up. COOL web site! You just need pitch from them.
your Maxprop. Call PYI tomorrow for your settings. You'll need to provide your engines HP and/@ RPM plus the transmission reduction ratio and your Maxprop diameter. The setting charts are probably online. They'll fix you up. COOL web site! You just need pitch from them.
Download Manual
To get a copy of the manual go to the PYI Max-Prop web page at http://www.pyiinc.com/index.php?section=max-prop&action=two-blade-classic&sn=2, select "Installation" in the far upper-right corner of web page, then sellect the appropriate manual (2-blade classic in your case?). hope this helps.
To get a copy of the manual go to the PYI Max-Prop web page at http://www.pyiinc.com/index.php?section=max-prop&action=two-blade-classic&sn=2, select "Installation" in the far upper-right corner of web page, then sellect the appropriate manual (2-blade classic in your case?). hope this helps.
- Status