I have a 2003 411 Oceanis Celebration 3 cabin model made in France. I am thinking about fitting a Jabsco quite flush electric heads conversion kit in both heads. I believe that the electric heads was an option on this model when new. Can anyone please advise if I need to run new wiring for the heads or is the wiring already fitted into the wiring loom/harness, and if so any idea where to find it.
Electric Heads Wiring
- Thread starter pmb
- Start date
- Status
Did you check the wiring schematic in the manual ? The manual should have several wiring diagrams one would be the hull harness. There should also be a corresponding number on the wire both in the heads and and the electrical panel.
Thanks for your reply Captn TJ. Unfortunatly I do not have a wiring schematic or the manual. Wonder if anyone else out there has this wiring schematic?
Check into one of the 411 groups such as this one. http://intersessions.com/411/
411 was a very popular boat in the US so there should be a pretty active group. Someone in the group should be able to scan their wire schematic for you. Since we talking about 12v systems they should be spot on regardless of where they are built. It wouldn't take much to confirm - and at the very least provide you with the basics.
411 was a very popular boat in the US so there should be a pretty active group. Someone in the group should be able to scan their wire schematic for you. Since we talking about 12v systems they should be spot on regardless of where they are built. It wouldn't take much to confirm - and at the very least provide you with the basics.
411 Manual
An electronic copy of the 411 manual can be found at http://community.ilovemybeneteau.com/boats.php?boat_id=72&type_id=1
An electronic copy of the 411 manual can be found at http://community.ilovemybeneteau.com/boats.php?boat_id=72&type_id=1
Thanks for that link MSN-Travelers, have downloaded it and found it very helpful. Unfortunatly the early models did not offer electric heads as an option, according to the early brochures. It seems this was only offered on the later models.
As I was unable to get the correct wiring diagram I have gone ahead using the recomended size AWG and laid new wiring for both heads to convert to electric Jabsco quite flush. Thanks to everyone for their input.
- Status