Compressor wont start

Status
Not open for further replies.
T

Tim

I have an Adler-Barbour model DCM-12 on my 1988 30 Catalina. When I turn the unit on, the fan comes on but I don't hear the compressor start (no vibration either). I've turned the thermostat up and down and left it running for 15-20 minutes but I still get no cooling. I've even jumped out the thermostat but no such luck. Any thoughts? PS, if the unit is low on freon, can it be re-charged? Tim
 
J

Jerry

Bad Electronic Module

I just had the same problem on a 1990 Catalina 42. You will have to order a new electronic module (AB-3016). You can order it from West Marine. I got mine for about $278. If your unit does need a recharge which it should not, that can be done. Any other questions, don't hesitate to ask.
 
B

Bill Thomas

compressor not starting

Jerry is correct. It may be the module. First eliminate any possibility of a voltage drop at the unit when it tries to start. A drop in voltage will aslo cause it not to run. The compressor will run regardless of the refrigerant level.It is rechargeable, but it is doubtful that is needed if it has been cooling to this point.
 
Status
Not open for further replies.