1984 Hunter 31 Thru Hull sizes

[thelilnauti]

Hello everyone,

I am getting ready to pull our 1984 Hunter 31 out for a much-needed bottom job. The boat is on a mooring 90 mins away so I am trying to see if anyone knows the thru-hull sizes?

I'm guessing they were all pretty standard and as far as I can tell there are the following thru-hulls;

1. Engine seawater in
2. Kitchen sink drain
3. Head seawater in
4. Holding tank out
5. Head sink out

Any information would be appreciated. I'm looking at ordering some Marelon thru-hulls. Would be great if anyone has any info on the sizes for the thru-hulls I've listed above.

Thanks.

 

[peterwynndavies]

Having been in a similar situation with my hunter I asked the forum but got the wrong answer. My advice is make the journey and measure them yourself.
As an aside have you looked at trudesign composite fittings?

 

[sail sfbay]

Ditto peterwynndavies!!.........While this thread does not answer your question it does address replacing old thru hull fittings on a Hunter 30:

Replacing Thru Hulls

Purchased an old Hunter 30 that I am in the process of getting into useable condition. Does anyone know of a way to change thru hull fittings without hauling the boat out. I have a few bronze valves that have corroded beyond opening and closing. Since it is the valve itself I really don't need...

forums.sailboatowners.com