zinc; they have been on for about 22 years, freshwater, 6 months/year. About half gone.
trailer2; I put a long 4x4 timber on the mast crutch. It is held off the cabin forward with a 2x4 at right angles and little 1x2 feet under that. I tack the 3/8 plywood (cut outs for winches and back stays) to the 4x4 every fall with roofing nails. Then cover with a small tarp.
trailer; I made the ramp with timbers bolted to rock with anchors. I have a small metal wheel near the trailer tongue that I can "steer" up a center ramp board. I use the trailer winch to haul out, and a small come-along to pull the boat onto the trailer.
keel1; VC Tar then VC17, needs new tar as rust is poking through. Rust was less with zincs installed.
zinc; they have been on for about 22 years, freshwater, 6 months/year. About half gone.
Left to right: Pad eye for traveler, jib cam cleat, raised and tilted jib winch, 150% Genoa track
Some instruments. The sonar and compass flip up on the hinge and are held by the bungy in my hand. A little voltmeter is wired to one of the circuits for battery monitoring. The little black speaker is a radio shack cheapie jacked into the VHF radio (out of the picture to the right under the stove). It really helps hearing the radio. The traveler ropes can be seen just outside.
Looking up in quarter berth. The jib cam cleat backing washers and nuts are lower left, Genoa track across the top (backing plate on the last two bolts as my track goes past the winch, great for downwind). Winch backing plate in the center as I raised my winch up an inch or two.
Chris14830

zinc; they have been on for about 22 years, freshwater, 6 months/year. About half gone.

There are no comments to display.

Media information

Album
H23 Mainsail and Traveler Pictures
Added by
Chris14830
Date added
View count
348
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
10603-1289600762-f676f14ecf4fddcca952283f16a3e0e7.jpg
File size
46.4 KB
Dimensions
600px x 480px

Share this media

Top Bottom