Rudder after cuts and holes drilled.
Traveler and step built and added August 18 2013
10 27 13 Preparing to Launch Williams Bay
1975 Venture 25 Stock Rudder before modification.
Rudder after cuts and holes drilled.
Rudder showing angle cut in top section, allowing the lower section to also angle more upward. I think a little safer traveling down the road. Seven small holes in top section to mount plates and one larger hole in lower section for the pivot bolt.
Aluminum plates 3/16" x 11-1/4" wide (at the bottom) x 18" high, cut with an electric hand jig saw in about 20 minutes. Used cut off material to make bracket for push down rod. A bolt in lower section holds a steel cable running back between plates up through pintle brackets (changed to 1/4" line above water line) to pulley under tiller, forward to self releasing clam cleat also under side of tiller.
I added two pieces of aluminum 29" long to each side of the tiller (extending 17" aft of the rudder). They are ground to a very snug fit into the brackets holding the tiller to the rudder. A line runs from the push down rod bracket upwards between 2 bolts with PVC spacers at the end of the aluminum, forward to a small cleat on the tiller. To raise the rudder, simply lift the tiller handle, pull the line taught & hold it over the cleat, push down tiller handle and the rudder pops right up. Also the system holds the rudder up while traveling.
J

Rudder after cuts and holes drilled.

There are no comments to display.

Media information

Album
2013 Mod's Rudder From Stock To Kick-up
Added by
jenquay
Date added
View count
265
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
19690-1379828207-148809d41f7f54718baaef9969b6d77b.jpg
File size
473 KB
Dimensions
600px x 800px

Share this media

Top Bottom