Out with the old. By the way if installing an access port it is much higher than I estimated on the Oday 19 put the port as high as you can. I estimated it way too low. Great thing with fiberglass is you can hide your mistakes.
Test fit of new block looks great. I will clean it up and add some sealant. Then to fix my mistake and place the access port in the correct position. I might just fill it back up with foam and seal it in as I should not need to mess with this again for many years.
Out with the old. By the way if installing an access port it is much higher than I estimated on the Oday 19 put the port as high as you can. I estimated it way too low. Great thing with fiberglass is you can hide your mistakes.
You can not even tell where the seam is. This is great stuff I will be using in many future projects.
New Bow Eye block cut from PVC board two 3.5" x 3/4" x 4" glued together. At least this will not rot out.
The factory used steel nuts not stainless. No wonder the bow eye was loose.
stern ready for gel coat
Still have a ways to go but it is getting there.
X

Out with the old. By the way if installing an access port it is much higher than I estimated on the Oday 19 put the port as high as you can. I estimated it way too low. Great thing with fiberglass is you can hide your mistakes.

There are no comments to display.

Media information

Album
Finally getting there with the repairs
Added by
XCIIGTWhipple
Date added
View count
288
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
21646-1404139176-c6a4c2bdfa4bb4e1bfbb3c0c0da4e41b.jpg
File size
42.3 KB
Dimensions
800px x 450px

Share this media

Top Bottom