Left to right: Pad eye for traveler, jib cam cleat, raised and tilted jib winch, 150% Genoa track
trailer; I made the ramp with timbers bolted to rock with anchors. I have a small metal wheel near the trailer tongue that I can "steer" up a center ramp board. I use the trailer winch to haul out, and a small come-along to pull the boat onto the trailer.
keel1; VC Tar then VC17, needs new tar as rust is poking through. Rust was less with zincs installed.
zinc; they have been on for about 22 years, freshwater, 6 months/year. About half gone.
Left to right: Pad eye for traveler, jib cam cleat, raised and tilted jib winch, 150% Genoa track
Some instruments. The sonar and compass flip up on the hinge and are held by the bungy in my hand. A little voltmeter is wired to one of the circuits for battery monitoring. The little black speaker is a radio shack cheapie jacked into the VHF radio (out of the picture to the right under the stove). It really helps hearing the radio. The traveler ropes can be seen just outside.
Looking up in quarter berth. The jib cam cleat backing washers and nuts are lower left, Genoa track across the top (backing plate on the last two bolts as my track goes past the winch, great for downwind). Winch backing plate in the center as I raised my winch up an inch or two.
Main sheet traveler pad eye backing washers, taken in quarter berth. I used regular and "fender" washers, then cut off excess bolt (3/16" SS) with a dremel tool.
Chris14830

Left to right: Pad eye for traveler, jib cam cleat, raised and tilted jib winch, 150% Genoa track

There are no comments to display.

Media information

Album
H23 Mainsail and Traveler Pictures
Added by
Chris14830
Date added
View count
917
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
9933-1283282742-38d8dbd3d836bc978ff11bc9244df5a3.jpg
File size
25.7 KB
Dimensions
600px x 450px

Share this media

Top Bottom