I set the motor in and moved it around to align the shaft. Didn't quite match up with the old holes, so had to drill new ones.
After the alignment, she is pinned down and ready to finish hooking up all the electrical, exhaust and fuel systems.
I set the motor in and moved it around to align the shaft. Didn't quite match up with the old holes, so had to drill new ones.
Flex Coupling. Getting this thing aligned with the shaft and the motor took a lot of time. After everything I read I knew that this has to be right on or the vibration can cause a bunch of problems.
Had to get this elbow off the old motor, hacksaw and hammer and lots of foul language finally got it off. 25 years makes for a solid connection!
The engine compartment was covered in soot, and the whole boat reeked like exhaust and diesel fuel. All four motor mounts were broken, and when I got the transmission loose of the prop shaft the motor rocked over and the exhaust didn't hold it because it was broke under the insulation!
The hardest part of the repower was this damn little shift cable. Took me grinding on it for a day to get the bolts out.
Engine compartment clean and ready to install the new diesel! Now if I can just remember what wires went where......
j_schoenfeld

I set the motor in and moved it around to align the shaft. Didn't quite match up with the old holes, so had to drill new ones.

There are no comments to display.

Media information

Album
Repower project
Added by
j_schoenfeld
Date added
View count
314
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
2292-1228533304-f01e191ab800dea36b59d181e19f2178.jpg
File size
29.1 KB
Dimensions
600px x 450px

Share this media

Top Bottom