I laid down some aluminum duct sealing tape then gave a coat of wax for insurance that it would not stick. I noticed that if I made a mold of the left side and just rotated it it would work for the damaged right side.
Start of new corner
Making a new corner
Test fit on the damaged right side looks like it will work fine after I remove the bolts I used to re-glue the deck to the hull. I just have to go score a gallon or 2 of resin to finish the process of making the part from this mold. I think I will have to beef it up some before doing so but I wanted to make sure it fit before wasting more time or product on it. The foam idea worked to some extent. I will use them for sanding blocks as they have the right curves. I was having trouble with it curing at the thickeness I was trying to do for strength.
I laid down some aluminum duct sealing tape then gave a coat of wax for insurance that it would not stick. I noticed that if I made a mold of the left side and just rotated it it would work for the damaged right side.
Thankfully there was more of the rail there than I thought.
Mess was harder to peel off the top but it is gone. I will clean this up with a small grinder.
Internal PVC pipe almost ready to drop.
X

I laid down some aluminum duct sealing tape then gave a coat of wax for insurance that it would not stick. I noticed that if I made a mold of the left side and just rotated it it would work for the damaged right side.

There are no comments to display.

Media information

Album
Repair Areas
Added by
XCIIGTWhipple
Date added
View count
292
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
17942-1363627122-5a2fa604abeb8110a174ff26bf1a8ea7.jpg
File size
38.4 KB
Dimensions
478px x 800px

Share this media

Top Bottom