Engine compartment clean and ready to install the new diesel! Now if I can just remember what wires went where......
Had to get this elbow off the old motor, hacksaw and hammer and lots of foul language finally got it off. 25 years makes for a solid connection!
The engine compartment was covered in soot, and the whole boat reeked like exhaust and diesel fuel. All four motor mounts were broken, and when I got the transmission loose of the prop shaft the motor rocked over and the exhaust didn't hold it because it was broke under the insulation!
The hardest part of the repower was this damn little shift cable. Took me grinding on it for a day to get the bolts out.
Engine compartment clean and ready to install the new diesel! Now if I can just remember what wires went where......
Crane day. Dropped the motor into the bottom of the boat. then got out of the way for the rest of the boats dropping in the lake.
Pulled the motor in the fall, and spent the winter scrubbing the bilge and rewiring. Also had to have a shop fabricate a piece for the exhaust.
Pulled the head to see if there was anything to save. There wasn't. The previous owner told me it was a high compression motor and sometimes needed a push to get moving. But with the head off I can't imagine that was the case...... Froze up like the arctic.
j_schoenfeld

Engine compartment clean and ready to install the new diesel! Now if I can just remember what wires went where......

There are no comments to display.

Media information

Album
Repower project
Added by
j_schoenfeld
Date added
View count
273
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
2036-1227330275-f8e638bf44a342e9198ca9bd7d00751b.jpg
File size
45.9 KB
Dimensions
600px x 449px

Share this media

Top Bottom