DSCN3839 Deck bedded to hull and pressed into place.
Cabin1202 V-berth area. Notice the hole drilled on the forward vertical surface of the sole pan. This was glassed over, as was the aft hole. Water was retained, and at best would seep to where I could removed it, but caused the rot in the bulkheads adjacent.
Cabin1050 Bunks removed. Bunk supports were also removed and replaced. The bunks are glassed to the hull, so I cut them with a jig saw about 2" in, cut the new bunks from the pattern and added the 2", then installed them over the old edge and screwed them in.
DSCN3843 Adhesive is 3M 5200.
DSCN3839 Deck bedded to hull and pressed into place.
DSCN3530 Old bulkhead was used as template for shaping 12mm PVC foam.
DSCN2957 Aft bulkhead removed.
Aft bulkhead cut and kicked out of place. Cockpit support tube has been removed to accomodate a 20 gallon water tank that now acts as the support.
Mark Major

DSCN3839 Deck bedded to hull and pressed into place.

There are no comments to display.

Media information

Album
Gunwale core replacement and subsequent wood replacement
Added by
Mark Major
Date added
View count
339
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
4508-1241838223-0cf427f6ecde15cccff3358c70b4ce94.jpg
File size
35.1 KB
Dimensions
600px x 450px

Share this media

Top Bottom