Cutting out bottom layer of cabin ceiling laminate for a redo
Cutting out bottom layer of cabin ceiling laminate for a redo
DSC 6471
Looking aft and up at the load bearing header that supports the mast. Originally the 3/4" bulk head had bolted to this header for vertical compression. I installed 3x3" oak studs on either side of the doorway for support and only a 1/2" thick plywood bulkhead.
The void in the middle is the mast base. Originally, they had a block of hard wood in there. Later, after I re-laminated the cabin ceiling I drilled a hole into this void from the top and filled with a fiber impregnated epoxy mix from west marine systems.
lower layer of glass cut away from the cabin roof for re-lamination. Much of the balsa core had to be chiseled away from the upper layer since not all of it was rotted. That turned out to be a much bigger job than I anticipated. The bottom of the top layer of glass needs to be pretty smooth when bonding the divinycell up to it.
Main bulkhead ripped out where head used to be.
I wished the carpet backing and glue came off as easy as the carpet.
jlillie

Cutting out bottom layer of cabin ceiling laminate for a redo

There are no comments to display.

Media information

Album
8.0a Demolition begins
Added by
jlillie
Date added
View count
756
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
22886-1417540624-edafc002dc51a32ae1f8de5771817d77.jpg
File size
62.6 KB
Dimensions
800px x 537px

Share this media

Top Bottom