9. Interior almost back together. Still have some engine room insulation to install this spring but 3 cylinders are sure quieter and smoother even without additional soundproofing. No more 1-2 knots against tidal currents, and should be a lot more reliable over the coming years.
- scottmcg
- Feb 8, 2012
- 0
- 0
6. Plumbing to new hot water tank. Installed outboard anti-scald valve to mix down the 180F hot water temp when using engine heat. Previously had replaced leaking fuel tank with 18gal. plastic one seen, needed to install fuel return hose to tank (previous yanmar didn't use one)
- scottmcg
- Feb 8, 2012
- 0
- 0
4. In the boat. Now the professional installers take over. Yard forklifted the engine to the salon floor, two guys muscled it onto the beds to check height. Spot on. Engine distributor let me borrow an engine jig but the installers didn't use it - just lifted the engine on and off until they had the alignment.
- scottmcg
- Feb 8, 2012
- 0
- 0
3. Cleanup and painting raised engine beds. I replaced all the bilge hoses and put in an additional electric bilge pump. Added plywood to the wall next to sink to seal up some openings and improve soundproofing. Beds needed to be raised a bit over 2" to accommodate new engine. Spacing between beds was fine. Glasswork was about $350.
- scottmcg
- Feb 8, 2012
- 0
- 0
2. Out goes the YSB12. The boom vang tackle brought the engine straight up, then used the mainsheet tackle to bring the engine back, swung the boom out to drop it on a dolly on the finger pier. Swing the boom slowly or the boat will heel and scare you to death, maybe put the engine in the water!
- scottmcg
- Feb 7, 2012
- 0
- 0
