Pulling the perkins: rear main seal, all new hoses and better type hose clamps, plumb in a rapid oil change fitting (flip a switch and the hot oil gets sucked out of the bottom of the engine), new oil pan gasket, pull the heat exchnager and clean, new motor isolators, re wire harnesses, rebuild starter, referb velvet drive, install new shaft and pyi dipless packing gland......wow what a 2 month project. this is my buddy that helps gotta love thos guys
- aduffE37
- Dec 28, 2010
- 0
- 0
red is coming off......subsequently brought the hul down to patent gelcoat and fixed blisters where they were....(not many) sealed in epoxy then five coats of interprotect and the addition of a wash down pum with new through hulls with counter sunk silicone bronse fasteners.
- aduffE37
- Dec 28, 2010
- 0
- 0
