3. Cleanup and painting raised engine beds. I replaced all the bilge hoses and put in an additional electric bilge pump. Added plywood to the wall next to sink to seal up some openings and improve soundproofing. Beds needed to be raised a bit over 2" to accommodate new engine. Spacing between beds was fine. Glasswork was about $350.
6. Plumbing to new hot water tank. Installed outboard anti-scald valve to mix down the 180F hot water temp when using engine heat. Previously had replaced leaking fuel tank with 18gal. plastic one seen, needed to install fuel return hose to tank (previous yanmar didn't use one)
5. Aluminum cap on the stringers, engine plumbed up and connected. Put in a dripless stuffing box. Fiberglass shop custom made an aqualift-type cannister muffler so the exhaust hoses fit perfectly. Engine fit into space without problems.
4. In the boat. Now the professional installers take over. Yard forklifted the engine to the salon floor, two guys muscled it onto the beds to check height. Spot on. Engine distributor let me borrow an engine jig but the installers didn't use it - just lifted the engine on and off until they had the alignment.
3. Cleanup and painting raised engine beds. I replaced all the bilge hoses and put in an additional electric bilge pump. Added plywood to the wall next to sink to seal up some openings and improve soundproofing. Beds needed to be raised a bit over 2" to accommodate new engine. Spacing between beds was fine. Glasswork was about $350.
2. Out goes the YSB12. The boom vang tackle brought the engine straight up, then used the mainsheet tackle to bring the engine back, swung the boom out to drop it on a dolly on the finger pier. Swing the boom slowly or the boat will heel and scare you to death, maybe put the engine in the water!
1.Beta 25 in the box. Took about 6 wks from ordering. Delayed in England - told "Not much work got done during the Royal Wedding"
scottmcg

3. Cleanup and painting raised engine beds. I replaced all the bilge hoses and put in an additional electric bilge pump. Added plywood to the wall next to sink to seal up some openings and improve soundproofing. Beds needed to be raised a bit over 2" to accommodate new engine. Spacing between beds was fine. Glasswork was about $350.

There are no comments to display.

Media information

Album
S2 9.2a gets a new Beta 25 (summer 2011)
Added by
scottmcg
Date added
View count
266
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S6000
Aperture
ƒ/4.6
Focal length
8.1 mm
Exposure time
1/30
ISO
200
Flash
On, fired
Filename
14791-1328688038-cd055a8f8212dee8200bcbec78b217ad.jpg
File size
53.2 KB
Date taken
Tue, 05 July 2011 8:15 PM
Dimensions
360px x 480px

Share this media

Top Bottom