Search results

  1. Slartibartfass

    Replacement traveler end cap, '85 CP-22

    Buy some Delrin or Starboard and shape a new one.... shouldn’t be too difficult....
  2. Slartibartfass

    Best Auto-pilot for the Capri 22

    Which version are you referring to?
  3. Slartibartfass

    Building a gimbaled stove holder for my CP-22 (COMPLETED)

    Yes before end of season. Works like a charme....
  4. Slartibartfass

    New Owner - Engine Size?

    Tohatsu 5HP LPG engine. Plenty of power even in nasty weather....
  5. Slartibartfass

    2019 Season Launch Prep

    No all is well. No leaks or stress cracks in the hull... Happened on the last race (pre-start) hit a rock at relatively low speed...
  6. Slartibartfass

    2019 Season Launch Prep

    Epoxied the Transducer yesterday. Added a small bead of 3M4000 around the top of the rubrail where it touches the hull. Still need to add some on the bottom of rubrail. Started to fix keel... After sanding: TotalBoat 2 part fairing compound: First coat: Second coat after some sanding...
  7. Slartibartfass

    Transducer installation

    3M 5200 works?
  8. Slartibartfass

    Adjustable genoa/jib car

    My latest upgrade. Slowly getting her ready....
  9. Slartibartfass

    Transducer installation

    Used plumbers putty so far to put the transducer in the forward lazarette in the cabin but it gets loose over time. Epoxy any good? Thoughts....?
  10. Slartibartfass

    Control line purchase

    I replaced my internal factory outhaul to a 8:1 purchase as I was never able to adjust the main under load.... Left the line where it exits the boom (safer to reroute to mast but not best option if you single hand on a small boat where any weight shift effects the course...).
  11. Slartibartfass

    Installing a Jib Roller Furler

    Moved the thread to the right sub forum...
  12. Slartibartfass

    Does the bow ride high

    I moved some of the heavier stuff (2 anchors and rope and chain) to the forward lockers to counteract all the weight at the back with the outboard and me and crew.
  13. Slartibartfass

    Capri 22 - hull numbers

    Good for you!
  14. Slartibartfass

    Proper sail for each wind speed

    You can also use a tacker that provides for an attachment point around the furled jib. If you have a hank on jib you could use a tack extension (forgot the correct term) to provide a high enough attachment point....
  15. Slartibartfass

    Proper sail for each wind speed

    Absolutely..... if you single hand a must in my opinion. Did that on my CP22 for both a asym and code zero/drifter sail....
  16. Slartibartfass

    Solar panels

    I have a 100w flex solar panel with a charge controller NOT permanently installed that I can use on overnight trips to recharge batteries if necessary. Also have a second spare battery on board. There really isn’t any room on the CP-22 for a permanent installation IMHO....
  17. Slartibartfass

    Optimal angle of heel

    The single best purchase I made to get better at sailtrim was the following: https://www.velocitek.com/pages/speedpuck Seeing the speed at all times gives you instant feedback for sail trim and heeling and its effect on speed....
  18. Slartibartfass

    Optimal angle of heel

    As much as it is still fun (and the Admiral or guests don't start screaming/panicking)... I had water coming over the coaming into the cockpit once when I was literally staring down on the water standing sideways in the boat. Obviously for racing purposes less heeling is usually better. I got...
  19. Slartibartfass

    Internal outhaul

    Here is a better picture that CD sent to me...
  20. Slartibartfass

    Internal outhaul

    I just did the exchange to a 8:1 today. @shnool thx for the install guide. Proofs my point to use this forum vs Facebook to exchange technical info and help.... Here’s how I did it: Step 1: Set up new 8:1 outhaul correctly based on CD picture on their website... Step 2: Unscrew back part of...