twodzusfittings's latest activity
-
Ttwodzusfittings replied to the thread Removing Shaft from flange on Universal M-25.A few years back I had to replace my entire stuffing box, first because it was old, second because the surveyor noted it on the...
-
Ttwodzusfittings replied to the thread WHICH SIDE DOES THE FUEL TANK COME OUT.Well, A new year and a new vigor to get things done. Well, let's say, damm it's bloody cold, let me see what I can remove, take home and...
-
-
Ttwodzusfittings replied to the thread CENTERBOARD HELP.This is a picture of my bilge with the up haul tube for the centerboard, after the rule bilge pump and the manual pump pick up have been...
-
-
Ttwodzusfittings replied to the thread CENTERBOARD HELP.@ Project_Mayhem. So tell me if I have the correct approach to this project. As in the picture you can see where I have damage. Here is...
-
-
Ttwodzusfittings replied to the thread CENTERBOARD HELP.Funny you should mention about screwing the bilge pump into the bilge without the use of any sealant. The PO had done the same. Since I...
-
Ttwodzusfittings replied to the thread CENTERBOARD HELP.I can get it down another 3 inches at the front, but still can't get it out. The Yard's equipment can't lift it any higher and the boat...
-
-
Ttwodzusfittings replied to the thread WHAT'S IN YOUR STOCKING (WALLET)?.Happy New Year to all. Santa must have forgotten I had a boat this year, but he did do well with giving me a new Mac Book Air, so now I...
-
Ttwodzusfittings replied to the thread 34/35 Prop Shaft Strut?.@ Alan 2210. Thanks for the great picture of your finished shaft/strutt/anode set up. My question to you is: Having replaced the cutlass...
-
TIt is that time of year when our babies are either sitting in the frigid waters of their docks, surrounded by 3/4 horsepower de-icers...
-
Ttwodzusfittings replied to the thread CENTERBOARD HELP.TOOL CREATION: Some folks call it a back scratcher, some even call it ugly! All I know is it is a long handled scraper to use inside the...
-
-
Ttwodzusfittings replied to the thread 34/35 Prop Shaft Strut?.Mmmm. Sounds like its worth looking into.
-
Ttwodzusfittings replied to the thread 34/35 Prop Shaft Strut?.@ dmax. Not hard at all. I started with a large Philip's head on a ratchet tool. That loosened two of the four machine screws. The other...
-
Ttwodzusfittings replied to the thread 34/35 Prop Shaft Strut?.I'm hiding my wealth from my kids!!!!!
-
Ttwodzusfittings replied to the thread 34/35 Prop Shaft Strut?.Not quite as nice as eherlihy's but still nice
-
-
Ttwodzusfittings replied to the thread CENTERBOARD HELP.
-
