sailor832's latest activity

  • sailor832
    sailor832 replied to the thread New to me Edel 665.
    had alcohol stove so no propane
  • sailor832
    sailor832 replied to the thread Hanging Bimini.
    I have A Hunter 34 and found this one to work and is quite high. You do have to do a little sewing to either add velco or zippers to...
    • 1595269793402.png
    • IMG_0428 (1).JPG
  • sailor832
    sailor832 replied to the thread New to me Edel 665.
    I would never store a propane tank on it side. By the way this is also the first boat I owned. I was living in Canada and used it to...
  • sailor832
    sailor832 replied to the thread Storage.
    I have only owned my 34 for about 1 1/2 years but I will admit storage is tight since it is only my wife and I on the boat most of the...
  • sailor832
    this is all done from the top the hole has to be drilled out to fit the rivet. just basically duplicating the tool they will sell you...
  • sailor832
    make your own puller 3/4 bolt a 1/2 plate with 3/4 hole. a hardened washer and a 3/4 nut. put the insert in put the plate over insert...
  • sailor832
    if it less than 1/4 INCH then the rivet nut would work
  • sailor832
    I did read a thread on here where they replaced the entire piece of angle iron and they cut a hole through the outside of the hull but I...
    • 1592310969863.png
  • sailor832
    It states in the manual that it is a 3/4 x 10 x 2" hex nut the 2" would be really oversize for a standard nut. I guess I would try and...
    • 1592238009867.png
  • sailor832
    The way the fiberglass is slow close to the rod it maybe holding the rod at a angle and not letting the threads start I would clear that...