Recent content by revir92

  1. revir92

    Islander 28

    I have a 1984 Islander 28. With vinyl zippered headliner. Want me to take pictures of it?
  2. revir92

    Cockpit locker water in O'Day 22

    Yes. Cockpit drain would be likely suspect. Also check to see if there are cracks in the low area where the cockpiit drain area, if there are even small cracks, repair them. Clean and dry this area really well to inpect.
  3. revir92

    New Sail Recommondations for Islander 28

    Z
  4. revir92

    Wheel to Tiller Conversion on I-28

    Have waited. Kind of warming up to the wheel. Good advice all.
  5. revir92

    I28 stove cooktop replacement.

    I recently purchased a beautiful Islander 28. She is complete and very well maintained, but has no cooktop. Trying to find out if anyone has replaced their cooktop in an Islander 28, and what make and model they would recommend? Thanks!
  6. revir92

    Wheel to Tiller Conversion on I-28

    Thanks everyone. I will wait.
  7. revir92

    Wheel to Tiller Conversion on I-28

    Waiting is a good thing. Stu. A voice of reason. Part of the waiting will involve research though!
  8. revir92

    Wheel to Tiller Conversion on I-28

    Just purchased an Islander 28. Love the boat, but... the wheel pulpit takes up half the cockpit! Not a big fan of the wheel anyway. Has anyone out there done a wheel to tiller conversion? Or can you point me to someone who has? Thanks!
  9. revir92

    Operational limits for heel - O'day 25

    Does anyone know if O'day ever published the operational limits for degrees of heel for the O'day 25?
  10. revir92

    Removing the sliding hatch at the companionway

    go Sailing Instead! No, am not removing the companion way just to get to an area I could not Cetol! The existing companionway slides were cracked and broken, with the last foot or so broken pretty good from foot traffic I suppose. The reason I Finished the new parts before installation was...
  11. revir92

    Removing the sliding hatch at the companionway

    Thanks every one. I have a pretty good handle on this now. Great resource. I wish I would have asked sooner, because I applied several coats of Cetol already. Sounds like I will be doing that again after get done installing, chisling and sanding the bungs! I figured it would be the only way to...
  12. revir92

    Removing the sliding hatch at the companionway

    I need to remove my sliding hatch above the companionway so I can replace the teak wood slides that it slides in. Does anyone know the trick to sliding the cover off prior to removing the old slides? (O'day 25) Thanks
  13. revir92

    Removing the sliding hatch at the companionway

    I need to remove my sliding hatch above the companionway so I can replace the teak wood slides that it slides in. Does anyone know the trick to sliding the cover off prior to removing the old slides? Thanks
  14. revir92

    jib sheet routing - roller furler-O'Day 25

    Image attached
  15. revir92

    jib sheet routing - roller furler-O'Day 25

    I am kind of new to learning all the terminology, but I believe I have a single block pulley on single sheave mounted to a 1" track that is about 40" long and starts just aft of my gennie winch on each side. I am finding that it is a simple system, kind of balky, but it is very difficult to...