KZW's latest activity

  • KZW
    KZW replied to the thread Replacing Pulpit.
    By the way, I was in a club race, on starboard, on the lay line to the windward mark. Boat 2 , 39 ft long, approaches on port. I call...
  • KZW
    KZW replied to the thread Replacing Pulpit.
    Stu, You have the benefit of a full marina with a yard, staffed by folks who work on boats. We don’t have that here. In my marina there...
  • KZW
    KZW replied to the thread Replacing Pulpit.
    Found a local, two-man shop that can make a custom pulpit. Six weeks. Hope it all works out
  • KZW
    KZW replied to the thread Fuel delivery issue.
    Tom J Can you post a picture of this connection?
  • KZW
    KZW replied to the thread Replacing Pulpit.
    I took tracing paper to the boat and mapped out pulpit footprint on the deck in full scale, including mounting holes. This will go to...
  • KZW
    KZW replied to the thread Replacing Pulpit.
    Ok, Catalina in Clearwater, as does Catalina Direct, currently get all their rails from Railmakers in CA. The late production C-310...
  • KZW
    KZW replied to the thread Replacing Pulpit.
    Anyone know the name of the company in Florida (or in proximity) that made bow pulpits and railings for the 310 when production was...
  • KZW
    KZW replied to the thread Replacing Pulpit.
    Crowfoot wrench cannot go around the corner far enough on top of the headliner. Thanks very much for the rail URLs. I’m in discussions...
  • KZW
    KZW replied to the thread Replacing Pulpit.
    Well, it appears none of the pulpit bolt, from either the forward foot pads or the aft foot pads have backing bolts. The post referenced...
    • Strbd Headliner.jpg
  • KZW
    KZW replied to the thread Fuel delivery issue.
    On my -310, the fuel will gravity feed as long as the tank is half full or more. The Racor, located under the rear bunk, is the lowest...
  • KZW
    KZW replied to the thread Replacing Pulpit.
    No, a long socket will only work if the headliner is cut where the scars will be visible afterward. It will take an open end wrench...
  • KZW
    KZW replied to the thread Replacing Pulpit.
    Attached is the drawing of the bow pulpit as provided by Catalina. I note here the Clearwater facility parts department one (1)...
    • IMG_20210828_Pulit 2.jpg
  • KZW
    KZW replied to the thread Replacing Pulpit.
    Thanks!
  • KZW
    KZW posted the thread Replacing Pulpit in Catalina 310.
    Has anyone replaced the pulpit on a C-310? - Do the bolts have nuts on the back like the stantions do? - If so, how do you...
  • KZW
    KZW replied to the thread Raw Water Pump Failure.
    Stu, Thanks!